Posted inSolid Mechanics
Elasticity, plasticity, and creep
Elasticity : Property of a material, by which it returns to its original dimension duringunloading Partially elastic : During…
Posted inSolid Mechanics
Hooke’s Law
i. The modulus of elasticity is the slope of stress-strain diagram in the linearly elastic region…
Posted inSolid Mechanics
Offset yield stress
i. When a material such as aluminum does not have an obvious yield point and yet…
Posted inSolid Mechanics
Stress-Strain Diagrams – Specimen under tension
a) Test results generally depend upon the dimensions of the specimen being tested. Test results in…
Posted inSolid Mechanics
Normal Strain,ε
a) The elongation of a segment is equal to its length divided by the total length L and…
Posted inSolid Mechanics
Normal Stress,σ
a) gives the intensity of stress uniformly distributed over the cross section in an axially loaded, prismatic bar of…
Posted inHeat & Mass Transfer
HEAT PIPES
1) A heat pipe is a simple device with no moving parts that can transfer large…
Posted inHeat & Mass Transfer
THE PRESENCE OF NON-CONDENSABLE GASES IN CONDENSERS
1) Most condensers used in steam power plants operate at pressures well below the atmospheric pressure…
Posted inHeat & Mass Transfer
DROPWISE CONDENSATION
1) Dropwise condensation, characterized by countless droplets of varying diameters on the condensing surface instead of a continuous…
Posted inHeat & Mass Transfer
FILM CONDENSATION
1) increases in the flow direction x because of continued condensation at the liquid–vapor interface. a) Heat in the…